Raspberry Pi 5 & Pimoroni NVME Base Housing by Nerdiy.de

This is my nice looking 3D printable housing for the Raspberry Pi 5 and the Pimoroni NVME Base PCB.
Features:
Precise fit for my Raspberry Pi 5 and the Pimoroni NVME Base PCB.
Efficient ventilation for optimal heat dissipation.
Material required for the Raspberry Pi 5 and the Pimoroni NVME Base PCB:
To build the case for the Raspberry Pi 5 and the Pimoroni NVME Base PCB, you will need the following accessories:
Raspberry Pi 5 4GB
Of course you also need a Raspberry Pi 5 for the case 🙂
Pimoroni NVME Base
The NVMe module to boot from an SSD.
Raspberry Pi 5 power supply
A reliable power supply for a stable power supply of the Raspberry Pi 5.
Micro SD card 64GB
Store the operating system and data on a reliable micro SD card.
M2 threaded insert
For the screw connection of the housing.
M2x20 countersunk head screw
Use these screws to securely fasten the Raspberry Pi and the NVMe module in the housing.
Note:
The links above are Amazon-affiliate links and are intended as examples of the material required. Be sure to select the correct specifications and sizes.
Print settings:
0,2mm layerthickness
20% infill
no support needed